Released in 1962 by the Electronic Industries Association (EIA) and BELL and other companies; the full name of the RS 232C standard (protocol) is the EIA-RS-232C standard, where EIA represents the Electronic Industries Association, RS represents the recommended standard ,…
Introduction to commonly used 9 signals
1.Contact control signal line: DSR: Data set ready, the data device is ready, indicating that the MODEM is ready for use. DTR: Data Terminal ready, the data terminal is ready, indicating that the data terminal can be used. RTS: Request…
Serial port rs485
The Electronic Industries Association (EIA) formulated and released the RS 485 standard in 1983, and it was revised by the Telecommunications Industry Association (TIA) and named TIA/EIA-485-A. Since the proposed standards proposed by EIA are all prefixed with “RS”, in…
Serial port rs422
RS-422 RS-422 (EIARS-422-AStandard) is the serial port connection standard for Apple’s Mac in osh computers. RS-422 is developed from RS-232 and is proposed to make up for the shortcomings of RS-232. RS 422 is a one-way, balanced transmission method for…
Siemens DP communication fault method
Siemens Profibus DP communication is often used for communication between PLC and other PLCs, remote substations, frequency converters, bus instruments and third-party DP equipment. The program is simple and the wiring is convenient. However, once the red light on the…
What is circuit breaker failure protection?
What is breaker failure protection? When the main protection action of the faulty electrical equipment issues a trip command but the circuit breaker refuses to operate, the protection action information of the faulty equipment and the current or other information…
what is capacitor
Capacitor is the most commonly used device in circuit design and is one of the passive components. Simply put, an active device is a device that requires an energy (electricity) source. It is called an active device. A device that…
Electrical control knowledge, practical algorithms for electrical control
1. 50 pieces of electrical control knowledge 1. According to the classification of uses, low-voltage electrical appliances are divided into control electrical appliances, main command electrical appliances, protective electrical appliances, distribution electrical appliances and executive electrical appliances. 2. According to…
Locating and solving the problem of low download rate in LTE network
When users use 2G and 3G networks, their main requirement for network quality is whether the quality of calls is stable. However, with the popularity of LTE network technology, many network users are more concerned about the speed of network…
Оптимизация устранения помех 802.11n Wifi
This article introduces in detail the common Wifi channel interference faults (including assisted channel interference and overlapping channel interference) in areas where APs are densely distributed. For different fault types, simulation experiments are conducted under different level environmental conditions to…